Kuken cooling tower fill

Short Description:

Kuken cooling tower fill is a Japanses brand cooling tower filler belong to cross flow filler , aslo suitable for square cooling tower filler.

There are many forms and structures of cooling tower fill,also called cooling tower film fill, each type has its own characteristics to fit various applications. Cooling tower fill is to put water surface area in contact with air as much as possible, for the longest amount of time possible. Pvc fills allow the water to form thin flowing sheets to expose as much water surface area as possible to the interacting flow.


  • Material: Thermal Formed PVC
  • Water temperature: -35℃~70℃
  • Application: square(cross flow) cooling tower
  • Sheet thickness: 0.25-0.45mm
  • Sheet gap: 19mm
  • Sheet width: 730mm 750mm 950mm
  • Sheet length: customized
  • Product Detail

    Product Tags

    This kind of PVC filler for Square Cooling Tower Parts with the advanced technical, long lifetime, low resistance, light weight. During the service, the fill can increase the water flow process. It is widely used in Square cooling tower. Characters acid proof alkali resisting anticorrosion for the organic solvent good performance of inflaming retarding Increasing cross-sectional area add water retention time.

    Product Detail

    The kuken cooling tower filling is the key part of the cooling tower. The process of gas and water heat exchange in the tower is mainly completed in the drenching filling, so the thermodynamic and resistance characteristics of the drenching filling are the main factors affecting the cooling effect of the cooling tower. The contact between the filler sheets is abnormally protruding, and the assembly block is formed by bonding two adjacent contact sheets. The lamellae are vertical, parallel and distributed in layers. The distance between the plates is determined by the height of the bonding protrusion, and the vertical channel is larger.

    Harm Of Irregular Replacement Of Cooling Tower Filling

    The filling of the cooling tower is a big hotbed for microbe, and the breeding speed is very fast. After sterilization and algae killing, the micro organism body will accumulate in the system. Moreover, PVC is a degradable plastic, and the combination of PVC monomer and biological corpse produces sludge which is easy to settle on the surface of heat exchanger. Its heat resistance capacity is higher than that of hard scale, and the thermal efficiency of the system is very low. During the annual overhaul, the desilting work is very big, and it is not easy to construct. Sometimes, chemical sedimentation is used, which will cause high cost, great damage to the equipment and shorten the service life of the equipment. Due to the poor cooling effect of the tower and the heat load of the production unit, it is necessary to increase the circulating water volume to take away the heat of the system, the energy consumption of the water pump and fan increases correspondingly, the packing is aging, brittle and deformed seriously, and the packing debris blocks the water pump and heat exchanger seriously, which seriously affects the continuous operation of the production.

    The Advantages Of Cooling Tower Filling For Kuken

    The cooling area of the cooling tower filling is effectively used; No deformation; Not broken; System water quality is good; High strength; Low noise and low floating water; Long life; No moss breeding, because of the three-dimensional characteristics of the honeycomb air inlet, so that most of the sunlight can not penetrate the tower body packing surface, so the packing surface is difficult to grow moss.


  • Previous:
  • Next:

  • Write your message here and send it to us